GM 10L80 With No Reverse? Check Third Gear and Code P2732

GM 10L80 With No Reverse? Check Third Gear and Code P2732

Next Gen Drivetrain Research & DevelopmentNovember 19, 2026

A Silverado that takes a moment to back up and one that has lost Reverse completely can sound like the same job over the phone. They deserve different entries on the work order. On certain 2024 GM trucks, one of the best clues to a missing reverse gear is what the truck did the last time it was in Drive.

Pin down what “no Reverse” means

If you select Reverse, feel a pause, and then the truck backs up normally, that’s delayed engagement. If the engine revs and the truck barely moves, describe it as slip. If it won’t back up at all, say so. Those details give the shop a better starting point than the word “slipping” by itself.

The same goes for forward gears. A truck that reaches third and stays there has a different complaint from one that makes a single rough shift into fourth. Report what you’ve already observed. If you’ve lost drive, let the shop handle further testing.

What the shop should check
Truck 2024 Silverado or Sierra with engine code L84 and transmission code MHT
Clues No Reverse, no shift past third gear, or code P2732
GM shop note PIP6002

Check the truck against GM’s bulletin

GM’s August 2024 service bulletin PIP6002 covers certain 2024 Chevrolet Silverado and GMC Sierra trucks with the L84 engine and MHT transmission. Have the shop check both codes against the vehicle’s build record.

GM lists loss of Reverse, failure to shift past third gear, and trouble code P2732. A truck can show one or more of those signs. When the application and fault match the bulletin, GM identifies an internal valve body problem and calls for replacing that assembly. The valve body is the part that routes fluid to apply the clutches needed for each gear.

Three questions worth asking about the estimate

Ask the shop which codes it found, which check points to the valve body on your particular truck, and how it plans to verify the repair. A good work order should spell out what gets replaced. It should also say how the shop will confirm that Reverse engages and the truck makes its forward shifts once the work is done.

Choosing a complete valve body or a DIY kit

If the shop confirms the condition in PIP6002, review our complete GM valve body with the technician. If you have a serviceable assembly and want to upgrade it on your own bench, the Next Gen Drivetrain® 10L80 DIY kit is built for that job. We make the proprietary components in-house and publish separate guides for different generations. You can match the hardware and read the procedure before taking the truck apart.

Have the VIN, transmission ID and casting marks ready when you order. For other symptoms, our 10L80 common problems guide covers the next set of questions.

Sources and photo credit

NGD parts photograph. Components shown illustrate the product family.

Leave a comment

Please note, comments must be approved before they are published