Ford’s Bronco Raptor Wins at Baja. Here’s the Lesson for Your Tow Rig.

Ford’s Bronco Raptor Wins at Baja. Here’s the Lesson for Your Tow Rig.

Next Gen Drivetrain Research & DevelopmentNovember 19, 2026

A truck can make a hard pull for a few seconds and look great doing it. Keeping that pace through dust and rough ground for nearly a full day is another job. Ford Racing’s Bronco Raptor won the Stock Mid-Size class at the November 13–14 Baja 1000. For owners who tow or spend time in low range, the interesting part is what Ford worked on before the race even started.

What Ford put through 970 miles of Baja

Brad Lovell, Loren Healy and Vaughn Gittin Jr. shared driving duties in the new race truck. They covered about 970 miles in under 24 hours and finished first in their class. Baja runs several classes, including purpose-built race trucks, so the class designation matters.

Ford built the Bronco around the production Raptor’s 3.0-liter EcoBoost V6. The team improved cooling, air intake and dust filtration. It also revised the bump stops, which help manage hard suspension hits. All of that equipment had to keep doing its job long after the first stretch of open desert.

The Bronco’s race in brief
Result First in its group
Distance About 970 miles
What Ford worked on Cooling and keeping dust out of the engine

Why slow work can build heat fast

Picture backing a loaded camper up a steep gravel drive. Road speed is barely walking pace, yet the engine is working hard. Little air is coming through the grille from the truck’s motion. Meanwhile, the torque converter is passing power through fluid, and the engine side can turn faster than the transmission side. Some of that energy becomes heat.

When the converter’s lockup clutch applies, the two sides turn together and that source of slip drops. That helps explain why the same truck can run comfortably on the highway and warm up on a slow climb. Ford didn’t publish transmission temperature data from the race truck, so there’s no Baja temperature target to copy.

What to record when your truck runs hot

Once you’re safely stopped, write down the trailer weight, outside temperature, road speed and length of the grade. Did the truck hold one gear or keep hunting? Did the temperature come back down on level ground? Those details give the shop something it can work with. If the dash displays a warning, follow the message and the instructions in your owner’s manual.

Also describe what you felt. A vibration at steady throttle and an RPM flare during a shift point the conversation in different directions. Our torque converter diagnostic guide explains the difference.

Choosing parts for your own truck

Start with how you use the truck and what the checks turn up. If you have a serviceable Ford valve body and want to upgrade it yourself, Next Gen Drivetrain® designs and machines the proprietary parts in our Ford 10R80 and 10R60 DIY kit. The installation guide is there to read before the pan comes off. Send us the VIN and transmission ID so we can confirm the fit for your trail or tow rig.

A race result can teach you plenty about sustained load. Your own truck’s build and test results should guide the parts order. For another look at how a factory drivetrain manages a long grade, read our Silverado HD towing article.

Sources and photo credit

Race photograph courtesy of Ford Racing.

Leave a comment

Please note, comments must be approved before they are published